7308 Nachi Angular Ball Bearing 40 Contact Angle Steel Cage 40mm x 90mm x 23mm Made in Japan

7308 Nachi Angular Ball Bearing, bearing is 40 Contact Angle, Steel Cage and Flush Ground, Made in Japan, inner diameter is 40mm, outer diameter is 90mm and width is 23mm. Item: 7308 Angular Ball Bearing Type: Nachi Angular Ball Bearing Cage: Steel Cage Dimensions: 40mm x 90mm x 23mm/Metric ID (inner diameter)/Bore: 40mm OD (outer diameter D1): 90mm Width/Height/thickness: 23mm Size: 40 x 90 x 23 mm Quantity: One Bearing Dynamic load rating Cr: 49,000 N Static load rating Cor: 33,000 N Limiting Speed: Grease Lubrication: 7,000 RPM Oil Lubrication: 9,200 RPM Made in Japan

Nachi Single Row Angular Contact Bearing

The raceways of both the inner and outer rings of this bearing type are made with a set contact angle. These bearings are non-separable. Since the balls are inserted utilizing counter-bore construction, a larger number of balls can be installed than in the case of Deep-groove ball bearings. Standard cage materials may be pressed steel, high-strength brass, or synthetic resin. Cage material is dependent on the bearing series and or service condition. Single-row Angular Contact ball bearings can sustain radial, axial or composite loads, however, any axial load must be in one direction. This bearing type is generally used in pairs to handle the induced load resulting from the internal axial force generated by the applied radial load. When mounting two single bearings in adjacent positions, NACHI provides these combination parts (pairs) with preadjusted clearance. Paired combination bearings are matched sets. Combination or paired bearings can be arranged BACK-TO-BACK (DB), FACE-TOFACE (DF), or in TANDEM (DT). DB or DF sets can sustain bidirectional axial loads.

Kit10032