7314BMU Nachi Angular Ball Bearing 40 Contact Angle Brass Cage & Flush Ground 70mm x 150mm x 35mm Made in Japan

7314BMU Nachi Angular Ball Bearing, bearing is 40 Contact Angle, Brass Cage and Flush Ground, Made in Japan, inner diameter is 70mm, outer diameter is 150mm and width is 35mm. Item: 7314BMU Nachi Ball Bearing Type: Nachi Angular Ball Bearing Dimensions: 70mm x 150mm x 35mm/Metric ID (inner diameter)/Bore: 70mm OD (outer diameter): 150mm Width/Height/thickness: 35mm Size: 70 x 150 x 35 mm Radial Clearance: C3 Cage: Brass Cage Quantity: One Bearing Dynamic load rating Cr: 118,000 N Static load rating Cor: 88,500 N Limiting Speed: Grease Lubrication: 3,600 RPM Oil Lubrication: 4,800 RPM Made in Japan

Nachi Single Row Angular Contact Bearing

The raceways of both the inner and outer rings of this bearing type are made with a set contact angle. These bearings are non-separable. Since the balls are inserted utilizing counter-bore construction, a larger number of balls can be installed than in the case of Deep-groove ball bearings. Standard cage materials may be pressed steel, high-strength brass, or synthetic resin. Cage material is dependent on the bearing series and or service condition. Single-row Angular Contact ball bearings can sustain radial, axial or composite loads, however, any axial load must be in one direction. This bearing type is generally used in pairs to handle the induced load resulting from the internal axial force generated by the applied radial load. When mounting two single bearings in adjacent positions, NACHI provides these combination parts (pairs) with preadjusted clearance. Paired combination bearings are matched sets. Combination or paired bearings can be arranged BACK-TO-BACK (DB), FACE-TOFACE (DF), or in TANDEM (DT). DB or DF sets can sustain bidirectional axial loads.

Kit10001