Reviewer:
Anonymous Person from Fort Nelson, BC Canada
I rolled them across the flat machined surface of my table saw to test them. Bent! Not was is needed for precision work on a 3D printer. I sent them back and ordered from somewhere else.
Was this review helpful to you?
0 of 0 people found the following review helpful:
For Prusa I3 MK3
February 5, 2019
Reviewer:
Keith Beaul from Penetanguishene, ON Canada
I would of given them a 5 star except these are cut rods with no beveled ends. The ends need to be filed down so as not to damage the installation of the linear bearings.
shafts were not straight 
For Prusa I3 MK3